The audio prompt will be triggered. And the select audio
index related audio content will be played according to the
congured play mode.
7.
Click Save.
8.
Oponal: Aer adding the device linkage, you can do one or
more of the following:
Edit Linkage
Sengs
Select the congured linkage sengs in the
device list and you can edit its event source
parameters, including event source and
linkage target.
Delete
Linkage
Sengs
Select the congured linkage sengs in the
device list and click Delete to delete it.
9.5.3 Congure Device Acons for Card Swiping
You can set the access control device's linkage acons for the
specied card swiping. When you swipe the specied card, it can
trigger the alarm output, host buzzer, and other acons on the
same device.
Steps
Note
It should be supported by the device.
1.
Click Access Control Linkage
Conguraon .
2.
Select the access control device from the list on the le.
3.
Click Add
buon to add a new linkage.
4.
Select the event source as Card Linkage.
5.
Enter the card number or select the card from the dropdown
list.
6.
Select the card reader where the card swipes to trigger the
linked
acons.
7.
In the Linkage Target area, set the property target to enable
this acon.
Buzzer on Controller
The audible warning of access control device will be
triggered.
Buzzer on Reader
The audible warning of card reader will be triggered.
Capture
The
real-me capture will be triggered.
Recording
The recording will be triggered.
Note
The device should support recording.
Alarm Output
The alarm output will be triggered for nocaon.
Alarm Input
Arm or disarm the alarm input.
72