HIKVISION DS-K1T605 Series User Manual

The real-me capture will be triggered.
Recording
The recording will be triggered.
Note
The device should support recording.
Alarm Output
The alarm output will be triggered for
nocaon.
Alarm Input
Arm or disarm the alarm input.
Note
The device should support alarm input funcon.
Access Point
The door status of open, close, remain open, or remain
closed will be triggered.
Audio Play
The audio prompt will be triggered. And the select audio
index related audio content will be played according to the
congured play mode.
7.
Click Save to save the sengs.
8.
Oponal: Aer adding the device linkage, you can do one or
more of the following:
Edit Linkage
Sengs
Select the congured linkage sengs in the
device list and you can edit its event source
parameters, including event source and
linkage target.
Delete
Linkage
Sengs
Select the congured linkage sengs in the
device list and click Delete to delete it.
9.5.5 Congure Device Acons for Person ID
You can set the access control device's linkage acons for the
specied person ID. When access control device detects the
specied person ID, it can trigger the alarm output, host buzzer,
and other acons on the same device.
Steps
Note
It should be supported by the device.
1.
Click Access Control Linkage Conguraon .
2.
Select the access control device from the list on the
le.
3.
Click Add buon to add a new linkage.
4.
Select the event source as Person Linkage.
5.
Enter the employee number or select the person from the
dropdown list.
6.
Select the card reader where the card swipes to trigger the
linked
acons.
74

HIKVISION DS-K1T605 Series Specifications

General

Brand	HIKVISION
Model	DS-K1T605 Series
Category	IP Access Controllers
Language	English