HIKVISION DS-K1T605 Series User Manual

Note
Enter the person's basic informaon rst. For details about
conguring person's basic informaon, refer to Congure Basic
Informaon.
3.
Click Add Face in the Basic Informaon panel.
4.
Select Take Photo.
5.
Connect the face scanner to the PC running the client.
6.
Oponal: Enable Verify by Device to check whether the facial
recognion device managed in the client can recognize the face
in the photo.
7.
Take a photo.
1) Face to the webcam of the PC and make sure your face is in
the middle of the
collecng window.
2)
Click
to capture a face photo.
3)
Oponal: Click to capture again.
4) Click OK to save the captured photo.
8.
Conrm to add the person.
-
Click Add to add the person and close the Add Person
window.
-
Click Add and New to add the person and
connue to add
other persons.
9.1.6 Collect Face via Access Control Device
When adding person, you can collect the person's face via access
control device added to the client which supports facial
recognion funcon.
Steps
1.
Enter Person module.
2.
Select an
organizaon in the organizaon list to add the person
and click Add.
Note
Enter the person's basic informaon rst. For details about
conguring person's basic informaon, refer to Congure Basic
Informaon.
3.
Click Add Face in the Basic Informaon panel.
4.
Select Remote
Collecon.
5.
Select an access control device which supports face
recognion
funcon from the drop-down list.
6.
Collect face.
1) Face to the camera of the selected access control device and
make sure your face is in the middle of the
collecng
window.
2)
Click to capture a photo.
3) Click OK to save the captured photo.
7.
Conrm to add the person.
-
Click Add to add the person and close the Add Person
window.
-
Click Add and New to add the person and connue to add
other persons .
37

HIKVISION DS-K1T605 Series Specifications

General

Brand	HIKVISION
Model	DS-K1T605 Series
Category	IP Access Controllers
Language	English