HIKVISION DS-K1T605 Series User Manual

9.1.7 Collect Fingerprint via Client
Collecng ngerprints locally means you can collect the
ngerprint via the ngerprint recorder connected directly to the
PC running the client. The ngerprints recorded can be used as
credenals of the persons to access the authorized doors.
Before You Start
Connect the ngerprint recorder to the PC running the client.
Steps
1.
Enter Person module.
2.
Select an organizaon in the organizaon list to add the person
and click Add.
Note
Enter the person's basic informaon rst. For details about
conguring person's basic informaon, refer to Congure Basic
Informaon.
3.
In the
Credenal Fingerprint panel, click +.
4.
In the pop-up window, select the collecon mode as Local.
5.
Select the model of the connected ngerprint recorder.
Note
If the ngerprint recorder is DS-K1F800-F, you can click Sengs
to select the COM the ngerprint recorder connects to.
6.
Collect the ngerprint.
1) Click Start.
2) Place and li your ngerprint on the ngerprint recorder to
collect the ngerprint.
3) Click Add to save the recorded ngerprint.
7.
Conrm to add the person.
-
Click Add to add the person and close the Add Person
window.
-
Click Add and New to add the person and
connue to add
other persons.
9.1.8 Collect Fingerprint via Access Control Device
When adding person, you can collect ngerprint informaon via
the access control device's
ngerprint module. The ngerprints
recorded can be used as credenals of the persons to access the
authorized doors.
Before You Start
Make sure
ngerprint collecon is supported by the access
control device.
Steps
1.
Enter Person module.
2.
Select an
organizaon in the organizaon list to add the person
and click Add.
Note
Enter the person's basic informaon rst. For details about
conguring person's basic informaon, refer to Congure Basic
Informaon.
38

HIKVISION DS-K1T605 Series Specifications

General

Brand	HIKVISION
Model	DS-K1T605 Series
Category	IP Access Controllers
Language	English