HIKVISION DS-K1T605 Series - Log Query; Test

Parameters Descripon
Restore to
Factory
Restore the system to the factory
sengs. The device will reboot aer the
seng.
Restore to
Default
Restore the system to the default
sengs. The system will save the
communicaon sengs and the remote
user sengs. Other parameters will be
restored to default.
8.9.3 Log Query
You can search the authencaon logs within a period of me by
inpung employee ID, card No., or user name.
Steps
1.
On the Home page, tap Log (Log) to enter the Log page.
Figure 8-16 Log Query
2.
Tap Card on the
le of the page and select a search type from
the drop-down list.
3.
Tap the input box and input the employee ID, the card No., or
the user name for search.
4.
Select a
me.
Note
You can select from Custom, Yesterday, This Week, Last Week,
This Month, Last Month, or All. If you select Custom, you can
customize the start me and the end me for search.
5.
Tap to start search.
The result will be displayed on the page.
8.9.4 Test
You can test the capability of the device's face detecon funcon,
voice prompt funcon, ngerprint authencaon funcon, me,
and buon.
Tap Test on the Home page to enter the Automac Test page.
Note
Some device models do not support ngerprint authencaon
funcon.
32