HIKVISION DS-K1T605 Series User Manual

Note
The device should support alarm input funcon.
Access Point
The door status of open, close, remain open, or remain
closed will be triggered.
Audio Play
The audio prompt will be triggered. And the select audio
index related audio content will be played according to the
congured play mode.
8.
Click Save.
When the card
(congured in Step 5) swipes on the card reader
(congured in Step 6), it can trigger the linked acons
(congured in step 7).
9.
Oponal: Aer adding the device linkage, you can do one or
more of the following:
Delete
Linkage
Sengs
Select the congured linkage sengs in the
device list and click Delete to delete it.
Edit Linkage
Sengs
Select the congured linkage sengs in the
device list and you can edit its event source
parameters, including event source and
linkage target.
9.5.4 Congure Device Linkage for Mobile
Terminal's MAC Address
You can set the access control device's linkage acons for the
specied MAC address of mobile terminal. When access control
device detects the specied MAC address, it can trigger the alarm
output, host buzzer, and other
acons on the same device.
Steps
Note
It should be supported by the device.
1.
Click Access Control Linkage Conguraon .
2.
Select the access control device from the list on the
le.
3.
Click Add
buon to add a new linkage.
4.
Select the event source as Mac Linkage.
5.
Enter the MAC address to be triggered.
Note
MAC Address Format: AA:BB:CC:DD:EE:FF.
6.
In the Linkage Target area, set the property target to enable
this
acon.
Buzzer on Controller
The audible warning of access control device will be
triggered.
Buzzer on Reader
The audible warning of card reader will be triggered.
Capture
73

HIKVISION DS-K1T605 Series Specifications

General

Brand	HIKVISION
Model	DS-K1T605 Series
Category	IP Access Controllers
Language	English