HIKVISION DS-K1T605 Series - Page 60

Display the card informaon when authencang.
Display Person Informaon
Display the person informaon when authencang.
Overlay Person Info. on Picture
Display the person informaon on the captured picture.
Voice Prompt
If you enable this funcon, the voice prompt is enabled in
the device. You can hear the voice prompt when operang in
the device.
Upload Pic.
Aer Linked Capture
Upload the pictures captured by linked camera to the system
automacally.
Save Pic. Aer Linked Capture
If you enable this funcon, you can save the picture
captured by linked camera to the device.
Press Key to Enter Card Number
If you enable this
funcon, you can input the card No. by
pressing the key.
Wi-Fi Probe
If you enable this funcon, the device can probe the
surrounding
communicaon devices' MAC address and
upload the MAC address to the system. If the MAC address
match the specied MAC address, the system can trigger
some linkage
acons.
3G/4G
If you enable this funcon, the device can communicate in
3G/4G network.
4.
Click OK.
5.
Oponal: Click Copy to, and then select the access control
device(s) to copy the parameters in the page to the selected
device(s).
Congure Parameters for Door/Elevator
Aer adding the access control device, you can congure its
access point (door or oor) parameters.
Steps
1.
Click Access Control Advanced
Funcon Device Parameter .
2.
Select an access control device on the le panel, and then click
to show the doors or oors of the selected device.
3.
Select a door or oor to show its parameters on the right page.
4.
Edit the door or
oor parameters.
Note
•
The displayed parameters may vary for dierent access
control devices.
•
Some of the following parameters are not listed in the Basic
Informaon page, click More to edit the parameters.
Name
Edit the card reader name as desired.
51