HIKVISION DS-K1T605 Series User Manual

Door Contact
You can set the door sensor as remaining closed or
remaining open. Usually, it is remaining closed.
Exit Buon Type
You can set the exit buon as remaining closed or remaining
open. Usually, it is remaining open.
Door Locked Time
Aer swiping the normal card and relay acon, the mer for
locking the door starts working.
Extended Open
Duraon
The door contact can be enabled with appropriate delay
aer person with extended accesss needs swipes her/his
card.
Door Open Timeout Alarm
The alarm can be triggered if the door has not been closed
in a
congured me period. If it is set as 0, no alarm will be
triggered.
Lock Door when Door Closed
The door can be locked once it is closed even if the Door
Locked Time is not reached.
Duress Code
The door can open by inpung the duress code when there
is duress. At the same
me, the client can report the duress
event.
Super Password
The specic person can open the door by inpung the super
password.
Dismiss Code
Create a dismiss code which can be used to stop the buzzer
of the card reader (by entering the dismiss code on the
keypad).
Note
•
The duress code, super code, and dismiss code should be
dierent.
•
The duress code, super password, and the dismiss code
should be dierent from the authencaon password.
•
The length of duress code, super password, and the dismiss
code is according the device, usually it should contains 4 to 8
digits.
5.
Click OK.
6.
Oponal: Click Copy to , and then select the door/oor(s) to
copy the parameters in the page to the selected
doors/oor(s).
Note
The door or oor's status duraon sengs will be copied to
the selected door/oor(s) as well.
Congure Parameters for Card Reader
Aer adding the access control device, you can congure its card
reader parameters.
52

HIKVISION DS-K1T605 Series Specifications

General

Brand	HIKVISION
Model	DS-K1T605 Series
Category	IP Access Controllers
Language	English