HIKVISION DS-K1T605 Series - Page 62

Steps
1.
Click Access Control Advanced Funcon Device Parameter .
2.
In the device list on the
le, click to expand the door, select a
card reader and you can edit the card reader's parameters on
the right.
3.
Edit the card reader basic parameters in the Basic Informaon
page.
Note
•
The displayed parameters may vary for dierent access
control devices. There are part of parameters listed as
follows. Refer to the user manual of the device for more
details.
•
Some of the following parameters are not listed in the Basic
Informaon page, click More to edit the parameters.
Name
Edit the card reader name as desired.
OK LED Polarity/Error LED Polarity/Buzzer Polarity
Set OK LED Polarity/Error LED Polarity/Buzzer LED Polarity of
main board according to the card reader parameters.
Generally, adopts the default sengs.
Minimum Card Swiping Interval
If the interval between card swiping of the same card is less
than the set value, the card swiping is invalid. You can set it
as 0 to 255.
Max. Interval When Entering PWD
When you
inpung the password on the card reader, if the
interval between pressing two digits is larger than the set
value, the digits you pressed before will be cleared
automacally.
Alarm of Max. Failed Aempts
Enable to report alarm when the card reading aempts
reach the set value.
Max. Times of Card Failure
Set the max. failure aempts of reading card.
Tampering Detecon
Enable the an-tamper detecon for the card reader.
Communicate with Controller Every
When the access control device cannot connect with the
card reader for longer than the set me, the card reader will
turn
oine automacally.
Buzzing Time
Set the card reader buzzing me. The available me ranges
from 0 to 5,999s. 0 represents connuous buzzing.
Card Reader Type/Card Reader Descripon
Get card reader type and descripon. They are read-only.
Fingerprint Recognion Level
Select the ngerprint recognion level in the drop-down list.
Default Card Reader Authencaon Mode
53