HIKVISION DS-K1T605 Series - Page 88

When you work for certain period aer end-work me on
workday, you will reach dierent overme level: overme
level 1, overme level 2 and overme level 3 . You can set
dierent pay rate for three overme levels, respecvely.
Pay Rate
Set corresponding pay rates for three overme levels, which
can be generally used to calculate total work hours.
Overme Rule for Non-Workday
You can enable overme rule for non-workday and set
calculaon mode.
4.
Click Save.
Congure Aendance Check Point
You can set the card reader(s) of the access point as the
aendance check point, so that the authencaon on the card
readers will be recorded for aendance .
Before You Start
You should add access control device before
conguring
aendance check point. For details, refer to .
Steps
Note
By default, all card readers of the added access control devices
are set as aendance checkpoint.
1.
Enter the Time & Aendance module.
2.
Click Aendance Sengs Aendance Check Point to enter the
Aendance Check Point Sengs page.
3.
Oponal: Set Set All Card Readers as Check Points switch to o.
Only the card readers in the list will be set as the aendance
check points.
4.
Check the desired card reader(s) in the device list as
aendance check point(s).
5.
Set check point
funcon as Start/End-Work, Start-Work or
End-Work.
6.
Click Set as Check Point.
The congured aendance check point displays on the right
list.
Congure Holiday
You can add the holiday during which the check-in or check-out
will not be recorded.
Add Regular Holiday
You can congure a holiday which will take eect annually on
regular days during the
eecve period, such as New Year's Day,
Independence Day, Christmas Day, etc.
Steps
1.
Enter the Time &
Aendance module.
2.
Click
Aendance Sengs Holiday to enter the Holiday Sengs
page.
3.
Check Regular Holiday as holiday type.
4.
Custom a name for the holiday.
79