Hioki ST5540 - Page 115

6.6 Printing Measurement Data (as required)
109
6
Chapter 6 Measurements
4. For switches one to eight of the DIP SW1, set the ON/OFF status as shown in the table below.
To set to ON, press the ON LINE button once and to set to OFF, press the FEED button once.
The setting is printed out after the ON LINE or FEED button is pressed to allow to confirm the
new setting. To change the settings, repeat from step 1.
: Use these settings for the HiTESTER.
After switch eight is set, the following messages are printed out.
Continue? :Push 'On-line SW'
Write? :Push 'Paper feed SW'
5. Press the ON LINE button and provide the following settings for DIP SW2 and DIP SW3.
6. After setting for the switch number 8 of DIP SW 3 is made, press the ON LINE or FEED switch to
complete settings.
The following message is printed out.
Dip SW setting complete!!
Software DIP SW 1 settings
Switch
No.
Function ON (Press ON LINE) OFF (Press FEED)
1 Input method Parallel
Serial
2 Printing speed
High Low
3 Auto loading
Enable Off
4 CR function Carriage return and line feed
Carriage return
5 Setting command
Enable Disable
6 Printing density
(set to 100%)
OFF
7 ON
8
ON
Software DIP SW 2 settings
Switch
No.
Function ON (Press ON LINE) OFF (Press FEED)
1 Print mode
Normal printing (40 columns) Condensed printing
(80 columns)
2 User-defined characters back-
up
Enable Disable
3 Character type
Ordinary characters Special characters
4 Zero font 0 Ø
5 International
character set
ON
6
ON
7 ON
8
ON
Software DIP SW 3 settings
Switch
No.
Function ON (Press ON LINE) OFF (Press FEED)
1 Data bit length
8 bits 7 bits
2 Parity permission Without With
3 Parity condition
Odd Even
4 Flow control
H/W BUSY XON/XOFF
5 Baud rate
(19200bps)
OFF
6
ON
7
ON
8 OFF