8.7 Command Message Description
193
8
Chapter 8 Controlling the Instrument From a Computer
Note
• Use this command after executing the :MODE command to activate the mea-
surement mode.
• Use this command after using the
:NETWork command to enter the B1 or
B2 network.
• Use this command after executing the
:MODE command to activate Touch
current : Enclosure - Earth, Touch current : Enclosure - Enclosure, Patient
leakage current:SIP/SOP, Total patient leakage current : SIP/SOP,
Free cur-
rent
.
Other manual measurements: Sets and queries the application of 110% of
rated voltage(only ST5540)
To Next Page
Loading...
