8.7 Command Message Description
200
Error
An execution error occurs in the following cases :
• During automatic measurement
• When a mode other than "leakage current mode" is set
• When a Network other than "B1 or B2" is set
• Setting not possible under existing conditions
For details, see the table below.
An execution error occurs when none of S10, S12 and S13 can be set.
• Use this command after executing the
:MODE command to activate the mea-
surement mode.
• Use this command after using the
:NETWork command to enter the B1 or
B2 network.
• Settings may not be possible for some equipment under test and measure-
ment modes. For details, see the table below.
Note
• Use this command after executing the :MODE command to activate the mea-
surement mode.
• Use this command after using the
:NETWork command to enter the B1 or
B2 network.
• Settings may not be possible for some equipment under test depending on
equipment under test setting and mode. For details, see table on next page.
When S10, S12 or S13 can be set, turn off the settings that cannot be set.
Sets and queries switches(only ST5540)
To Next Page
Loading...
