Hioki ST5540 - Page 242

8.7 Command Message Description
236
Function
Example
Command
Query
Sets the allowable value (lower limit) to On/Off.
Returns all allowable value (lower limit) On/Off settings as alphabetic charac-
ters.
Command
:SYSTem:LOWer ON
Sets all allowable values (lower limit) On/Off to On.
Error
Query
Response
:SYSTem:LOWer?
:SYSTEM:LOWER ON (Headers: ON)
ON (Headers: OFF)
All allowable values (lower limit) On/Off has been set to On.
An execution error occurs in the following cases:
• When measurement mode is selected (Command)
• When a mode other than "leakage current mode" is set (Command)
Note
Use this command after using the :MODE command to turn off (and no mea-
surement mode is selected).
Turning On/Off an allowable value (lower limit) after all allowable values (lower
limit) have been turned On/Off will not result in a query asking to turn On/Off all
allowable values.Use the query command for turning an allowable value On or
Off to check.
Sets and queries all allowable values (lower limit) On/Off
Sets and queries the coefficients for all allowable values (lower limit)
Syntax
Command
Query
Response
:SYSTem:LOWer:COEFficient <numerical value>
:SYSTem:LOWer:COEFficient?
<numerical value>
<numerical value>=5 to 99(NR1)
Function
Example
Command
Query
Sets the coefficient for all allowable values (lower limit).
Returns the set coefficients for all allowable values (lower limit) as a numeric
value.
Command
:SYSTem:LOWer:COEFficient 10
Sets coefficients for all allowable values (lower limit) to 10%.
Error
Query
Response
:SYSTem:LOWer:COEFficient?
:SYSTEM:LOWER:COEFFICIENT 10(Headers: ON)
10 (Headers : OFF)
Coefficient settings for all allowable values (lower limit) are set to 10%.
An execution error occurs in the following cases :
• When measurement mode is selected (Command)
• When a mode other than "leakage current mode" is set(Command)
Note
• Use this command after using the :MODE command to turn off (and no mea-
surement mode is selected).
• The unit is [%]. Fractions are rounded up when 0.5 or greater and rounded off
when less than 0.5.