Hioki ST5540 - Page 245

8.7 Command Message Description
239
8
Chapter 8 Controlling the Instrument From a Computer
Sets and queries the fuse check (At power on)
Syntax
Command
Query
Response
:SYSTem:TEST:FUSE:STARt <characters>
:SYSTem:TEST:FUSE:STARt?
<characters>
<characters>=ON/OFF
ON : Performs fuse check at power on.
OFF : Does not perform fuse check at power on.
Function
Command
Sets fuse check at power on.
Example
Command :SYSTem:TEST:FUSE:STARt ON
Performs fuse check at power on.
Query
Response
:SYSTem:TEST:FUSE:STARt?
:SYSTEM:TEST:FUSE:START ON (Headers: ON)
ON (Headers: OFF)
Performs fuse check at power on.
Queries the relay check
Syntax
Query
Response
:SYSTem:TEST:RELay?
<characters>
<characters>=OK/NG
OK: RELAY CHECK OK
NG: RELAY CHECK NG
Function
Query Performs a relay check and returns the result as alphabetic characters.
Example
Error
Query
Response
:SYSTem:TEST:RELay?
:SYSTEM:TEST:RELAY OK (Headers : ON)
OK (Headers : OFF)
The result of the relay check is OK.
An execution error occurs in the following cases :
• When measurement mode is selected
• When a mode other than "leakage current mode" is set
Note
• Use this command after using the :MODE command to turn off
(and no measurement mode is selected).
Sets and queries the relay check (At power on)
Syntax
Command
Query
Response
:SYSTem:TEST:RELay:STARt <characters>
:SYSTem:TEST:RELay:STARt?
<characters>
<characters>=ON/OFF
ON : Performs relay check at power on.
OFF : Does not perform relay check at power on.
Function
Command
Sets fuse check at power on.