Hioki ST5540 - Page 304

Appendix3 List of default settings
A14
Touch cur-
rent (Enclo-
sure - Earth)
measurement manual manual manual
polarity positive phase positive phase –
equipment sta-
tus
normal normal normal
Other applied
voltages
OFF OFF OFF
Application of
specific voltage
–––
s10 OFF OFF –
s12 OFF OFF –
s13 – – –
filter ON ON ON
target current ACDC ACDC ACDC
range AUTO AUTO AUTO
allowable value
: upper limit :
normal
100.0
A 100.0 A100.0 A
allowable value
: upper limit :
fault
500.0
A 500.0 A–
allowable value
: lower limit :
ON/OFF :
normal
OFF OFF OFF
allowable value
: lower limit :
ON/OFF : fault
OFF OFF –
Touch cur-
rent (Enclo-
sure-
Enclosure)
measurement manual manual manual
polarity positive phase positive phase –
equipment
status
normal normal normal
Other applied
voltages
OFF OFF OFF
Application of
specific voltage
–––
s10 OFF OFF –
s12 OFF OFF –
s13 – – –
filter ON ON ON
target current ACDC ACDC ACDC
range AUTO AUTO AUTO
allowable value
: upper limit:
normal
100.0
A 100.0 A100.0 A
allowable value:
upper limit: fault
500.0
A 500.0 A–
allowable value:
lower limit: ON/
OFF: normal
OFF OFF OFF
allowable value:
lower limit: ON/
OFF: fault
OFF OFF –
default setting
Class I Class II Internally powered
Leakage
current mode
item Type B Type BF Type CF Type B Type BF Type CF Type B Type BF Type CF
*
( ) is the value after DC switching