Hioki ST5540 - Page 318

Appendix3 List of default settings
A28
Initializing item
Touch current (Enclosure - Line) measurement manual manual –
condition L side L side
Selected line internal internal
filter OFF OFF
target current ACDC ACDC
range AUTO AUTO
allowable value : upper limit : normal – –
allowable value : upper limit : fault 3.500 mA 3.500 mA
allowable value : lower limit :
ON/OFF : normal
––
allowable value : lower limit :
ON/OFF : fault
OFF OFF
default setting
Leakage current mode item Class I Class II Internally
powered
*
( ) is the value after DC switching
item default setting
Mode setting Voltmeter:range AUTO voltage AC+DC
Protective conductor ammeter:Range 50 mA Current AC+DC
Save data No data
Panel Load No data
Language not initialize
Connect/VA Check The connection/VA check at each power ON operation
Relay Check Check at each power ON operation
Fuse Check Check at each power ON operation
Polarity Change Previous
Frequency Range 15 Hz
Auto Measure Last Measurement State
Indication Unit AUTO
Date/Time not initialize
Interface USB
Beep Key input:ON
Judgement:FAIL
110% voltage output:ON
Output terminal T2:ON
Back Light Constant ON