65
Limiting Current Flowing Through Measured Object (Current Limiter)
4.9 Limiting Current Flowing Through Measured
Object (Current Limiter)
The current limiter can be used to limit currents owing through measured objects. Thus, the
measured objects can be charged faster, and it will also prevent objects from being damaged.
The current in the CHARGE terminal can also be restricted by the current limiter.
The value you can set varies according to the charge setting (p. 64) and the measurement
voltage setting (p. 41) (p. 66).
IMPORTANT
If the measurement voltage setting or the charge setting is changed after the current limiter has
been set and if the current limiter exceeds the upper limit, the current limiter is set to the largest
value among the settable values.
Procedure to display the settings screen: (Measurement screen) MENU key > [MEAS] tab
1.8 mA, 5 mA, 10 mA, 50 mA (default setting: 5 mA)
Press the F3 key [↓] or F4 key [↑] to select a value.
4
Applied Measurement
To Next Page
Loading...
