Replacing the Drive I/O Module 12–1
Hitachi Unified Storage Hardware Service Guide
Replacing the Drive I/O
Module
CBL Controller Boxes have a Drive I/O Module. This chapter
describes how to replace a Drive I/O Module in a CBL Controller
Box on Hitachi Unified Storage system.
The following topics are covered in this chapter:
Precautions when replacing the Drive I/O Module
Replacing the Drive I/O Module on a CBL Controller Box
NOTE: This chapter assumes you have read the electrostatic
guidelines and other information in Chapter 3, Procedures before
and after replacing components. If you have not, review this
information and then return to this chapter.
To Next Page
Loading...