2–10 Hardware description
Hitachi Unified Storage Hardware Service Guide
Rear panel
•
Figure 2-10: CBSS Controller Box rear panel
Legend:
¶
Two Controllers
Controller 0 (left) and Controller 1 (right)
?
Host Interface Option
See Host I/O Boards for CBSS and CBSL Controller Boxes on page 2-40.
?
Fibre Channel Ports
See Fibre Channel ports on page 2-35.
?
PATH 0 (left) and PATH 1 (right) Expansion Ports
Connect to a DBS, DBL, or DBX Drive Box. LED above each port shows
when a link is made:
• BLUE ON = Drive Box is connected and link status is normal.
• ORANGE ON = a Storage Navigator Modular 2 wizard indicates that a
SAS (ENC) cable must to be inserted into the port.
?
LAN 0 Maintenance Port
• Left LED: Link Status (green)
• Right LED: Port Activity (yellow)
See Maintenance port on page 2-37.
?
LAN 1 Management Port
• Left LED: Link Status (green)
• Right LED: Port Activity (yellow)
See Management port on page 2-37.
?
Power Unit
See Power Unit for CBXSS, CBXSL, CBSS, and CBSL Controller Boxes on
page 2-45.
?
Main Switch
Powers the storage system ON and OFF. When power is OFF, turn on power
by holding this switch longer than 1 second. When power is ON, turn off
power by holding this switch longer than 3 seconds.
?
Reset Switch and Controller LEDs
Use the Reset switch only when instructed by Hitachi Support. For LEDs,
see CBSS/CBSL controller LEDs on page 2-34.
?
Uninterruptible Power Supply Port
To Next Page
Loading...