15–2 Upgrading a Hitachi Unified Storage 130 system
Hitachi Unified Storage Hardware Service Guide
Upgrade procedure at-a-glance
The following steps summarize the procedures to follow when upgrading a
Hitachi Unified Storage 130 to a Hitachi Unified Storage 150. Some steps
are performed at the Hitachi Unified Storage 130, while other steps are
performed at the Hitachi Unified Storage 150.
Getting started
1. Reviewing prerequisites on page 15-3
2. Preparing for the upgrade on page 15-4
3. Unpacking the CBL and Drive Box on page 15-5
Steps performed at the Hitachi Unified Storage 130
1. Starting Hitachi Storage Navigator Modular 2 on page 15-7
2. Registering the Hitachi Unified Storage system on page 15-7
3. Locking extra-cost options on page 15-9
4. Install firmware on the CBSL/CBSS on page 15-12
5. Removing drives from the Hitachi Unified Storage 130 on page 15-16
Steps performed at the Hitachi Unified Storage 150
1. Installing drives in the Hitachi Unified Storage 150 on page 15-26
2. Mounting the CBL on page 15-29
3. Power on the Hitachi Unified Storage on page 15-30
4. Installing firmware on the Hitachi Unified Storage 150 on page 15-32
5. Changing the number of Drive I/O Modules on page 15-34
6. Configuring the storage system serial number on page 15-36
7. Registering the Hitachi Unified Storage 150 on page 15-38
8. Completing the upgrade on page 15-38
To Next Page