Replacing the I/O Module (ENC) 13–1
Hitachi Unified Storage Hardware Service Guide
Replacing the I/O Module
(ENC)
DBL and DBS Drive Boxes have customer-replaceable I/O Module
(ENC) components. This chapter describes how to replace an I/O
Module (ENC) component on DBL and DBS Drive Boxes.
The following topics are covered in this chapter:
Precautions when replacing the I/O Module (ENC)
Replacing the I/O Module (ENC)
NOTE: This chapter assumes you have read the information in
Chapter 3, Procedures before and after replacing components. If
you have not, review this information and then return to this
chapter.
To Next Page
Loading...