3-22
[Setting of switch/check point/LED display and the like]
- Setting of switch
[SW1]
< Print target sensor >
- When supplying power from the IJ printer :
Set as shown in the following table depending on the output form of the print
target sensor.
- When using the external dedicated power supply:
Set as shown in the following table is not depending on the output form of the
print target sensor.
< Rotary encoder >
- When supplying power from the IJ printer :
Set as shown in the following table depending on the output form of the rotary
encoder.
- When using the external dedicated power supply :
Irrespective of the output form of the rotary encoder, set as shown in the
following table depending on the power supply voltage.
[SW2]
Switching that the input signal connection is NPN/PNP is set.
*) Input signal: Print stop, Reciprocative printing, Deflection voltage ON/OFF,
Run, Reset , Stop
Both of bits are put on the bottom
Both of bits are put on the up position.
Set only the right bit to the up position.
Set only the left bit to the up position.
Setting is performed according to the specification of the encoder.
(Refer to the setting by types of the specification described below.)
Setting is performed according to the specification of the print target detector .
Setting is performed according to the specification of the encoder.
Setting is performed according to the specification of Print target
detector.
(Refer to the setting by types of the specification described below.)
Print target detector signal noise filter setting
( Time constant: t = 2.2 millisecond)
To Next Page
Loading...
Need help?
General
