2-25
2.8 System reset
●Set the set values on the “Printing data”, “User pattern” and “Maintenance” screens to the values of
initial condition.
●
Perform this function when the EZJ128 board or the EZJ126 board is replaced in a state allowing
no backup.
●
If this function is performed, perform setup and/or adjustment according to the contents described
in “3.2.4 EZJ128 board.” and “3.3.1 EZJ126 board.”
●
This setting is carried out with the IJ printer in “Stop” state.
1 The maintenance menu is displayed.
If Prev. menu Next menu is not displayed on the maintenance menu, set the service
personnel maintenance mode on the login user selection screen.
2 Press System reset on the second page of the maintenance menu.
The confirmation message is then displayed.
3 Press OK .
“Please wait” is displayed.
After the completion of the system reset, the screen returns to the service maintenance
screen.
〔For work after System reset 〕
Please execute work according to [3.2.1 EZJ128 board (controller board) (12)-(13) of
replacement procedurenotes].
Please execute work according to [3.3.1 EZJ126 board (MPU board) (12)-(13) of
replacement procedure].
To Next Page
Loading...
Need help?
General
