Hitachi IJ UX Service Manual

6-3
6.2 Faults – Ink-stop type
6.2.1 Ink Low Fault
Is there ink in the ink reservoir?
Uncap the ink reservoir
and add ink.
Open the maintenance cover.
No
Yes
END
Yes
No
● Turn OFF the power.
● Unscrew and pull out the sensor
section.
Clean the electrode with JK wiper
moistened with makeup.
Yes
No
Return the sensor
section to its position.
Return the sensor
section to its position.
Ink Low Fault
Is the fault cleared by
pressing the Clear key?
Is an insoluble substance
deposited on the sensor?
No
Remove and joint the following
connectors.
● EZJ126: CN13
● EZJ132: CN1, CN3
Is the fault cleared
by power-on reset?
END
1
OK
Yes
3
Is the connection
harness
conducting?
Replace the harness.
2
NG
Replace the EZJ126 board.
2
1
No
Is the
fault cleared
by power
-on reset?
Yes
3

Hitachi IJ UX Specifications

General

Brand	Hitachi
Model	IJ UX
Category	Printer
Language	English