Hitachi IJ UX Service Manual

5-21
②Heat the filled part by a warm air of a drier (500W equivalent) for 7 to 8 minutes
and cure the surface.
Caution
：
Keep the drier 50 to 100mm away so as not to deform the tube by
keeping it too close.
９ Push “Beam adjustment” on the “Circulation control screen” to adjust the position of the ink beam.
１０
Perform ink drop.
１１
Perform the auto phase gain adjustment.
シリコン注入のコツ
ディスペンサの保管
Knack of infusing the
When infusing the silicone into the dispenser, perform it as shown below (to
purge air).
Metallic needle
Cylinder
Put the
silicone in
Place the needle on
the upside
Cylinder
Downside is NG
Wait until the silicone comes
down to the piston
Piston
Place the needle on
the upside
Push the piston as if to purge air
Storage of the dispenser
If left as-is after use, the silicone hardens in the metallic needle portion of the
dispenser. Plug it by using a clip and so on.
Clip
Drier
Nozzle
50 to 100mm

Hitachi IJ UX Specifications

General

Brand	Hitachi
Model	IJ UX
Category	Printer
Language	English