Hitachi IJ UX - Page 234

6-16
6.2.12 Charge Voltage Fault
・Allow the print head surface
to adequately dry.
・Clear the fault.
・Restart the IJ printer.
Charge Voltage Fault
Remove the print head cover.
Pour the makeup over the
charge electrode area to clean it.
Yes
Replace the EZJ126 board.
No
Does the printer become
ready?
END
Yes
Replace the print head.
No
Does the printer become
ready?
Replace the EZJ125 board.
Does the printer become
ready?
Yes
No
Replace the multiple power supply.
Does the printer become
ready?
Yes
No