Hitachi IJ UX Service Manual

2-9
3 Measure TP12 of the EZJ125 board with an oscilloscope and make sure it is
within the range of DC250V ± 15V.
When confirmation is completed, press Abort and you can stop work before 3 minutes elapse.
Charge voltage
[Waveform of charge voltage confirmation]
← GND level
For the position of the board and test pins, refer to “3.3.6 EZJ125 board.”

Hitachi IJ UX Specifications

General

Brand	Hitachi
Model	IJ UX
Category	Printer
Language	English