system.
Waste disposal must comply with all appropriate regulations.
Consult the appropriate regulatory agency for further information.
● Exercise caution to avoid inadvertently disconnecting, forcibly
pulling, or bending piping tubes.
Since the ink and makeup in some portions of piping tubes are pressurized, they
may splash into your eyes or mouth or onto your hands or clothing.
If any ink or makeup enters your eyes or mouth, immediately flush with warm or
cold water and consult a physician.
● While the printer is operating, do not look into the ink ejection hole
in the end of the print head.
Ink or makeup may enter your eyes or mouth or soil your hands or clothing.
If any ink or makeup enters your eyes or mouth, immediately flush with warm or
cold water and consult a physician.
● Before servicing the printer, be sure to stop the ink ejection.
Because ink or makeup may splash into your eyes or mouth or onto your hands or
clothing. If any ink or makeup enters your eyes or mouth, immediately flush with
warm or cold water and consult a physician.
● If an earthquake, fire, or other emergency occurs while the printer
is engaged in printing or just turned on, press the Main power
switch to turn off the power.
● The printer must be managed in compliance with all appropriate
regulations.
Check the supplementary manual (Ink) for the ink used.
● Use Hitachi approved consumables and periodic replacement
parts.
Using products that are not designated by Hitachi could cause s failure in
certain functions.
WARNING
To Next Page
Loading...
Need help?
General
