3-26
[Setting of switch/check point/LED display etc.]
- Setting of switch
[SW1]
< Print target sensor >
- When the power is supplied from the IJ printer :
Set as shown in the following table depending on the output form of the print
target sensor.
- When the external dedicated power supply is used:
Set as shown in the following table regardless of the output form of the
print target sensor.
< Rotary encoder >
- When the power is supplied from the IJ printer :
Set as shown in the following table depending on the output form of the rotary
encoder.
- When the external dedicated power supply is used:
Irrespective of the output form of the rotary encoder, Set as the
following table depending on the power supply voltage.
[SW2] EZJ127A board only
Set the input signal connection of NPN/PNP.
*) Input signal: Print stop, Reciprocative printing, Deflection voltage ON/OFF,
Run, Reset, Stop
Both bits are put downward.
Both bits are put upward.
Set only the right bit upward.
Set only the left bit upward.
Setting of
factory default
Setting is performed according to the specification of the encoder.
(Refer to the setting by types of the specification described below.)
Setting is performed according to the specification of the print target detector.
Setting is performed according to the specification of the encoder.
Setting is performed according to the specification of Print target
detector.
(Refer to the setting by types of the specification described below.)
Print target detector signal noise filter setting
( Time constant: t = 2.2 milliseconds)
To Next Page
Loading...
