4-80
5 Reset the time of the R air filter to 0 on the “Parts usage time management” screen.
4.18 Check on Exhaust Duct dripping
The exhaust contains the vapor of makeup and it will be liquefied when cooled down.
Depending on the IJP’s installation environment, there will be a case that there is a big
difference between IJP’s inside temperature and the operating temperature.
When IJP is installed or when IJP is serviced at periodical maintenance, please check the
items below:
(1) Is there any wiring routed around the exhaust duct, such as the power cord, the electrical
signal wirings, etc.? Should there be dripping the wire/cable coating may get cracked.
Please reroute the wiring and call customer’s attention.
(2) Is there any track of the dripping?
Please propose a tray for dripping to customer.
There may be a possibility that the ink/makeup was supplied to the ink/makeup
reservoir more than needed and it overflowed from the reservoir’s vent and ran to the
exhaust duct. Please call customer’s attention.
To Next Page
Loading...
