Hitachi UX Twin Nozzle - Time of Preparing for Printing

2-42
2.15 Time of preparing for printing
●Set time between the print target detection signal is input and printing.
Time between print target detection signal is input and printing
Model
Set Value
Time of preparing
65um,
UX-D
Standard
Approx. 5.5ms
●Please note when “Short” is set and continuous printing was performed at frequent intervals,
printing quality may drop. Print quality is maintained if print standby time is saved.
[Standard] O N
Print target sensor signal O F F
Approx.7ms Approx.7ms
Print specifications screen
Printing operation
Printing
Printing