Hitachi UX Twin Nozzle - System Reset

2-27
2.8 System reset
●Reset the values on the “Printing data”, “User pattern” and “Maintenance” screens to the initial
values..
●Perform this function when the EZJ128 board or the EZJ133 board is replaced without backup.
●If this function is performed, perform setup and/or adjustment according to the contents described
in “3.2.1 EZJ128 board” and “3.3.1 EZJ133 board”.
●This setting is carried out with the IJ printer in “Stop” state.
1 The maintenance menu is displayed.
If Prev. menu Next menu is not displayed on the maintenance menu, set the service
personnel maintenance mode on the login user selection screen.
2 Press System reset on the second page of the maintenance menu.
The confirmation message is then displayed.
3 Press OK .
“Please wait” is displayed.
After the completion of the system reset, turn the printer OFF and then back ON
after 10 seconds.
〔For work after System reset 〕
Please execute work according to [3.2.1 EZJ128 board (controller board) (12)-(13) of
replacement procedure].
Please execute work according to [3.3.1 EZJ133 board (MPU board) (12)-(13) of
replacement procedure].
For information on changing to the service personnel maintenance mode, refer
to “2.1 Setting of service personnel maintenance mode.”
= = = = = System Reset Confirmation = = = = =
241
OK
Cancel
The system will be reset.
This function is executed upon replacement of Board
EZJ128 or EZJ133.