2-53
2.18 Rescue soft
- Use this function when the IJ printer does not start up during turn on procedure.
- Use the Rescue soft which is prepared by Hitachi.
- This function will initialize all registered data and settings, ensure reinstall all data and settings with
“Back up” data.
This function will be initialized the settings as below items on the list, ensure reinstall all data and
settings with “Back up” data.
1 Prepare Rescue USB.
1) Rename ‘UXTrescNNN_ex’ to UXTrescNNN.exe
2) Execute (double click) UXTrescNNN.exe for Create “UTVUP” folder and “cj9resc_ux”.
3) Copy the “UTVUP” folder and “cj9resc_ux” to the USB root directly.
2 Rescue procedure.
1) Be sure to turn off the power.
2) Insert a rescue memory USB into the slot.
3) Turn on the power.
Download procedure start automatically.
4) Turn off the power when the download is completed.
5) Take the rescue USB from the USB port.
6) Turn on the power, the message of Model-key Information Difference will show up. Turn the
Power OFF and then back On after 10 seconds.
7) Turn off the Power. Insert the system data USB memory then turn on the power with the system
data USB memory card inserted. Download will be performed automatically.
8) Insert a USB with backup data into the USB port.
9) Turn on the power and data copy to the printer.
10) Turn off the printer and take the USB from the USB port.
[Caution]
● Format the USB with FAT16 or FAT32 by PC when USB memory error occurred.
● Turn off the printer then turn on again when some fault was occurred during rescue procedure or
the rescue process is stopped.
To Next Page
Loading...
Need help?
General
