Hitachi UX Twin Nozzle - Page 113

3-37
[Connection to the external connection terminal block (EZJ119A -TB2)]
Pin No.
Name
Input /Output
Remarks
1
Ready
NC
100VAC/0.5A or 30VDC/1A
2
NO
100VAC/0.5A or 30VDC/1A
3
COM
4
Fault
NC
100VAC/0.5A or 30VDC/1A
5
NO
100VAC/0.5A or 30VDC/1A
6
COM
7
Warning
NC
100VAC/0.5A or 30VDC/1A
8
NO
100VAC/0.5A or 30VDC/1A
9
COM
Terminal specification: M4
[Setting of switch 3]
The ready output selector switch (SW3) is the switch which determins to enable or
disable of Ready signal output.
Switch setting
Ready output status
When this setting is employed, Ready output signal is enabled. The
path between the TB2 terminals opens or closes depending
on whether IJ printer state is Ready or not.
When NC contact (break contact) is used, Ready output signal is
disabled. The path between the TB2 terminals opens as shown in
the table below regardless whether IJ printer state is Ready or not.
When NO contact (make contact) is used, Ready output signal is
disabled. The path between TB2 terminals 1 and 3 opens and the
path between TB2 terminals 2 and 3 closes as shown in the table
below regardless whether IJ printer state is Ready or not.
SW3
3
1
2
SW3
3
1
2
SW3
3
1
2
(Factory default）
Ready state
Not-ready state
TB2
1-3 contact
Open
1-3 contact
Closed
2-3 contact
Closed
2-3 contact
Open
Ready state
Not-ready state
TB2
1-3 contact
Open
1-3 contact
Open
Ready state
Not-ready state
TB2
2-3 contact
Closed
2-3 contact
Closed
1-3 contact
Open
1-3 contact
Open