Hitachi UX Twin Nozzle Service Manual

4-16
5 Remove the fixing screws (2 positions) of the solenoid valve.
[Caution] Put wiping paper under the solenoid valve to provide for an ink drip.
6 Clean the portion stained with ink and then install the new solenoid valve in reverse order
of the procedures above.
[Caution] Securely set the O-ring in the groove of the solenoid valve.
Pay extra attention not to cause the O-ring to fall off or pinched.
Fixing screws
(2 Positions)
Solenoid valve
O-ring(S24)
O-ring4.7-E227
MV25
(Green)
MV23
(Orange)
MV28
(Gray)
MV8
Gray
MV7
Purple
MV6
Blue
MV5
Green
MV4
Yellow
MV3
Orange
MV2
Red
MV1
Brown

Hitachi UX Twin Nozzle Specifications

General

Brand	Hitachi
Model	UX Twin Nozzle
Category	Printer
Language	English