Hitachi UX Twin Nozzle - Page 20

1-14
１ Remove the inlet cover. (Fastening screws x 4)
２ Mount the power cable in the inlet and mount the inlet cover.
Be sure to unplug the power cable from the electrical outlet before
performing work.
Be careful not to get shocked when checking with the cover open.
Precautions concerning electrical shock
•Be sure to mount the inlet
cover.
•Wrap the attached cable seal
around the power cable and
set in the position shown in
the figure.
Caution
Cable seal
Power cable
Inlet base
Inlet cover
Side cover
Inlet cover