Hitachi UX Twin Nozzle - Page 212

4-78
4 Remove the Fastening screws (4 locations) of the Intake fan unit assembly.
5 Disengage the Intake fan harness, connector and remove the Intake fan unit assembly.
6 Remove the Fastening screws (4 locations) of Intake fan cover assembly.
7 Pull out the harness and remove the Intake fan unit from two positioning bosses.
8 Install the new Intake fan unit by reverse order of the procedures above.
Positioning bosses (two locations)
Harness routing
Fastening screws
(4 locations)
Intake fan unit assembly
Fastening screws (4 locations)
Intake fan harness connector
冷却ユニットクミ
Intake fan cover assembly
Intake fan unit assembly