Hitachi UX Twin Nozzle - Page 271

6-29
6.2.14b (N2)Ink Heating Unit Temperature Sensor Fault
- On detecting this fault, the IJ printer automatically sets the “Ink temperature
correction” to (disable).
“System environment setup: Ink temperature correction (enable)  (disable)”
After getting rid of the fault, reset the Ink temperature correction to (enable).
“System environment setup: Ink temperature correction (disable)  (enable)”
- In the condition of the “Ink temperature correction (disable), ” the “Ink Temperature
Correction Notice” message appears each time the power is turned on.
(See “1.6 Heating of Ink” in the Instruction manual”.)
Caution
!
(*1): When you replace Heating unit, refer to “5.6 Heating unit
replacement”.
(*2): When you replace EZJ133 board, refer to [Replacement
procedures of EZJ133 board] in “3.3.1 EZJ133 board
(MPU board)”.
[Caution]
Be sure to check that there is no wrong connection of harnesses
by referring to [Connector numbers and Identifying method of
harnesses] in “3.3.20 Electrical Connection Diagram”.
(N2)Ink Heating Unit
Temperature Sensor
Fault
Disconnect the EZJ133 board
CN38 connector and reconnect it.
Replace the heating unit.*1
Replace the EZJ133 board*2.
Resume the
operation.
Yes
No
▪ Clear the fault.
▪ From the maintenance screen, place
the heating unit in the operating mode. *)
▪ Restart the IJ printer.
Does the fault recur?
Yes
No
Does the fault recur?
▪ Clear the fault.
▪ From the maintenance screen, place
the heating unit in the operating mode. *)
▪ Restart the IJ printer.
*) Refer to the following caution.
*) Refer to the
following caution.