OPERATING INSTRUCTIONS
ThinPrep 2000 Processor Operator’s Manual
5A.23
3 – Firmware Version:
Pressing
3
displays the Firmware screen. This screen allows the operator to view the version of the
Program Memory Card in use without turning off the power and removing the card. Technical Ser-
vice may access this screen during troubleshooting.
To return to the Status Menu, press STOP.
7 – Maintenance:
Pressing
7
from the Main Menu displays the following screen.
To return to the Main Menu, press STOP. The processor must be completely empty of supplies before
continuing with Maintenance.
Firmware:
VERSION X.XX
COMPUTED CRC: XXXX
FIRMWARE CRC: XXXX
Maintenance:
1 - LCD ADJUST
2 - WASTE SYSTEM
3 - SERVICE MODE
To Next Page
Loading...
