Hologic thinprep 2000 - SELECTING AND INITIATING A SEQUENCE

OPERATING INSTRUCTIONS FOR PROCESSING COBAS AMPLICOR™ CT/NG
SAMPLES
ThinPrep 2000 Processor Operator’s Manual 5B.15
5B
SELECTING AND INITIATING A SEQUENCE
The ThinPrep 2000 Processor has several program modes in its program card. There are two primary
types of modes:
1. Sample processing sequences
2. Diagnostic
The sample processing sequences are used to process different kinds of specimens.
The diagnostic modes are used to display the status of the instrument or to perform maintenance
procedures. The Main Menu, shown below, is displayed whenever the instrument is in its idle state.
The Main Menu contains the four sequences for sample processing. To view the diagnostic modes,
push the down arrow key and the menu will change to the following:
A description of the sequences is in Table 5B.1:
SECTION
K
Main Menu: Select
1-SUPER 4-GYN
2-FLU/FNA
3-MUCOID
↓- MORE
Main Menu: Select
6-STATUS 8-TEST
7-MAINT
STOP-PREVIOUS MENU