FUEL SYSTEM (PGM-FI)
5-35
3. IACV Circuit Continuity Inspection
Disconnect the ECM 33P (Black) connector.
Check the continuities between the ECM 33P
(Black) connector terminals and the IACV 4P
(Black) connector terminals.
Are there continuities?
YES – GO TO STEP 4.
NO – • Open circuit in Black/yellow or Black/
red wire
• Open circuit in Black/blue or Black/
orange wire
4. IACV Resistance Inspection
Measure the resistance at the IACV 4P (Black)
connector terminals.
Is the resistance within 99 – 121
Ω
(20
°
C/68
°
F
)
?
YES – Replace the ECM with new one, and
recheck; refer to Key Registration Proce-
dures (page 21-6)
NO – Faulty IACV
DTC 33-2 (EEPROM)
1. Recheck DTC
Clear the ECM self-diagnosis memory data (page
5-14).
Turn the ignition switch ON and engine stop
switch " ".
Recheck the ECM EEPROM
Is the DTC 33-2 indicated?
YES – Replace the ECM with new one, and
recheck; refer to Key Registration Proce-
dures (page 21-6)
NO – Intermittent failure
CONNECTION: A19 – Black/yellow
A27 – Black/red
A16 – Black/blue
A29 – Black/orange
TOOL:
Test probe 07ZAJ-RDJA110
A27
4P (Black) CONNECTOR
(Wire side/female terminals)
33P (Black) CONNECTOR
(Wire side/female terminals)
A19
A16
A29
Black/
red
Black/
blue
Black/
orange
Black/
yellow
CONNECTION: Black/yellow – Black/orange
Black/red – Black/blue
STANDARD: 99 – 121 Ω (20 °C/68 °F)
4P (Black) CONNECTOR
(Motor side/male terminals)
Black/
orange
Black/
blue
Black/
red
Black/
yellow
Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys.
email: info@motomatrix.co.uk
To Next Page
