FUEL SYSTEM (PGM-FI)
5-56
FUEL PUMP
INSPECTION
Turn the ignition switch ON and confirm that the
fuel pump operates for a few seconds.
If the fuel pump does not operate, inspect as follow:
Turn the ignition switch OFF.
Lift and support the fuel tank (page 3-5).
Disconnect the fuel pump unit 2P (Black) connector.
Turn the ignition switch ON and measure the volt-
age between the terminals.
There should be battery voltage for a few seconds.
If there is battery voltage a few seconds, replace the
fuel pump unit.
If there is no battery voltage, inspect the following:
– main fuse 30A
– sub fuse 20A (FI/Ignition)
– sub fuse 10A (Bank angle sensor)
– engine stop switch (page 20-32)
– fuel cut-off relay (page 5-58)
– engine stop relay (page 5-96)
– bank angle sensor (page 5-94)
– ECM (page 5-97)
REMOVAL
Remove the fuel tank (page 5-59).
Remove the fuel pump unit mounting nuts.
CONNECTION: Brown (+) – Green (–)
2P (Black) CONNECTOR
(Wire side/female terminals)
Brown
Green
Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys.
email: info@motomatrix.co.uk
To Next Page
