LIGHTS/METERS/SWITCHES
20-38
REMOVAL/INSTALLATION
Disconnect the wire connectors from the horn.
Remove the bolt, nut and horn.
Installation is in the reverse order of removal.
TURN SIGNAL RELAY
INSPECTION
1. Related Circuit Inspection
Check the following:
– burned bulb or non-specified wattage
– blown fuse
– ignition switch and turn signal switch func-
tion
– loose connectors
Check for the above items.
Are the above items in good condition?
YES – GO TO STEP 2.
NO – Replace or repair the malfunction
part(s)
2. Turn Signal Circuit Inspection
Remove the rear cowl (page 2-5).
Disconnect the turn signal 4P connector and
short the Gray and White/green terminals of the
wire harness side connector with a jumper wire.
Turn the ignition switch ON and check the turn
signal light by turning the turn signal switch on.
Does the light come on?
YES – GO TO STEP 3.
NO – Open circuit in related wires
4P CONNECTOR
TURN SIGNAL RELAY
Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys.
email: info@motomatrix.co.uk
To Next Page
