IMMOBILIZER SYSTEM (HISS)
21-12
IMMOBILIZER INDICATOR
(S/SA model)
Remove the front center cowl (page 2-10).
Disconnect the combination meter 16P (Black) con-
nectors.
POWER INPUT LINE INSPECTION
Measure the voltage between the Black/brown (+)
and Green/black (–) wire terminals.
There should be battery voltage when the ignition
switch is turned to "ON".
IMMOBILIZER INDICATOR LINE
INSPECTION
Measure the voltage between the White/red wire
terminal (+) and ground (–).
There should be battery voltage when the ignition
switch is turned to "ON".
• There should be no voltage for approx. two sec-
onds after the ignition switch is turned to "ON",
then the battery voltage should appear, if the
system is normal.
Viewed from harness side/
the 16P connector:
Green/black
Black/blown
Viewed from harness side/
the 16P connector:
White/red
Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys.
email: info@motomatrix.co.uk
To Next Page
