HYDRAULIC BRAKE
15-30
Install the brake hose with the oil bolt and new seal-
ing washers.
Push the eyelet joint against the stopper, then
tighten the oil bolt to the specified torque.
Secure the rear brake light switch wire with the
clamp of right footpeg holder.
Connect the rear brake light switch 2P (Black) con-
nector.
Fill and bleed the hydraulic system:
– CBF600SA/NA (page 15-8)
– CBF600S/N (page 15-11)
Install the right side cover (page 2-5).
FRONT BRAKE CALIPER (CBF600SA/
NA)
REMOVAL
Drain the front brake hydraulic system (page 15-7).
Remove the brake pads (page 15-15).
Remove the oil bolt, sealing washers and brake
hose eyelet joint.
TORQUE: 34 N·m(3.5kgf·m, 25 lbf·ft)
OIL BOLT
BRAKE HOSE
SEALING WASHERS
Avoid spilling fluid
on painted, plastic,
or rubber parts.
Place a rag over
these parts
whenever the
system is serviced.
Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys.
email: info@motomatrix.co.uk
To Next Page
