HYDRAULIC BRAKE
15-19
BRAKE DISC INSPECTION
Visually inspect the brake disc for damage or crack.
Measure the brake disc thickness with a microme-
ter.
Replace the brake disc if the smallest measurement
is less than the service limit.
Measure the brake disc warpage with a dial indica-
tor.
Check the wheel bearings for excessive play, if the
warpage exceeds the service limit.
Replace the brake disc if the wheel bearings are nor-
mal.
FRONT MASTER CYLINDER
REMOVAL
CBF600N/NA:
Remove the rear view mirror (page 13-8).
Drain the front hydraulic system (page 15-7).
Disconnect the brake light switch wire connectors.
Remove the brake hose oil bolt, sealing washers
and brake hose eyelet.
Remove the bolts from the master cylinder holder
and remove the master cylinder assembly.
SERVICE LIMITS:
FRONT: 3.5 mm (0.14 in)
REAR: 4.0 mm (0.16 in)
SERVICE LIMITS:
FRONT: 0.30 mm (0.012 in)
REAR: 0.30 mm (0.012 in)
Avoid spilling fluid
on painted, plastic,
or rubber parts.
Placearagover
these parts
whenever the
system is serviced.
CONNECTORS
OIL BOLT
SEALING WASHERS
BRAKE HOSE
MASTER CYLINDER
BOLTS
HOLDER
Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys.
email: info@motomatrix.co.uk
To Next Page
