ALTERNATOR
10-4
ALTERNATOR COVER REMOVAL
Remove the following:
– seat (page 2-4)
– left side cover (page 2-5)
– rear cowl (page 2-5)
– crankcase rear cover A (page 7-4)
Disconnect the alternator 3P (Black) connector.
Release the alternator wire from the clamps.
Unhook the alternator wire from the guide.
The alternator cover
(stator) is
magnetically
attached to the
flywheel, be careful
during removal.
Remove the bolts and alternator cover.
• Engine oil will run out when the alternator cover
is removed. Set a clean oil pan under the engine
and add the recommended oil to the specified
level after installation.
Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys.
email: info@motomatrix.co.uk
To Next Page
