FRAME/BODY PANELS/EXHAUST SYSTEM
2-3
SERVICE INFORMATION
GENERAL
• Work in a well ventilated area. Smoking or allowing flames or sparks in the work area or where gasoline is stored can
cause a fire or explosion.
• This section covers removal and installation of the body panels and exhaust system.
• Serious burns may result if the exhaust system is not allowed to cool before components are removed or serviced.
• Always replace the exhaust pipe gaskets after removing the exhaust pipe from the engine.
• When installing the exhaust system, loosely install all of the exhaust pipe fasteners. Always tighten the exhaust clamps
first, then tighten the mounting fasteners. If you tighten the mounting fasteners first, the exhaust pipe may not seat
properly.
• Always inspect the exhaust system for leaks after installation.
TORQUE VALUES
TROUBLESHOOTING
Excessive exhaust noise
• Broken exhaust system
• Exhaust gas leak
Poor performance
• Deformed exhaust system
• Exhaust gas leak
• Clogged muffler
Exhaust pipe joint nut 12 N·m (1.2 kgf·m, 9 lbf·ft)
Muffler mounting nut 22 N·m (2.2 kgf·m, 16 lbf·ft)
Exhaust pipe mounting nut 22 N·m (2.2 kgf·m, 16 lbf·ft)
Muffler band bolt 22 N·m (2.2 kgf·m, 16 lbf·ft)
Grab rail mounting socket bolt 27 N·m (2.8 kgf·m, 20 lbf·ft)
Front fender mounting bolt 12 N·m (1.2 kgf·m, 9 lbf·ft)
Rear view mirror mounting bolt
(CBF600S/SA)
14 N·m (1.4 kgf·m, 10 lbf·ft)
Upper cowl stay bolt (CBF600N/NA) 27 N·m (2.8 kgf·m, 20 lbf·ft)
Side cover socket bolt 4 N·m (0.4 kgf·m, 3.0 lbf·ft)
Mainstand pivot nut (CBF600SA/NA) 29 N·m (3.0 kgf·m, 21 lbf·ft)
Mainstand spring hook bolt 21.5 N·m (22 kgf·m, 16 lbf·ft)
Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys.
email: info@motomatrix.co.uk
To Next Page
