CYLINDER HEAD/VALVES
8-29
Be sure to align the
dowel pins in the
camshaft holder
align properly with
the holes in the
cylinder head
properly.
Install the each camshaft holder onto the camshafts.
Apply engine oil to the threads and seating surfaces
of the camshaft holder bolts.
Install the twenty holder bolts with new eight seal-
ing washers as shown.
Finger tighten the bolts.
Gradually tighten the camshaft holder bolts until the
camshaft holders lightly contact the cylinder head
surface.
Failure to tighten the camshaft holder in a criss-
cross pattern might cause a camshaft holder to
break.
Tighten all camshaft holder bolts in the numerical
order cast on the camshaft holders.
Install the cam chain guide B, and tighten the bolts.
TORQUE: 12 N·m(1.2kgf·m, 9 lbf·ft)
Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys.
email: info@motomatrix.co.uk
To Next Page
